Document

Accessories

CONE
Panel Diagrams Remarks
Metal Form A (m/m) B
  1. There are two diameters for inner units
    i.e. W5/16 and 3/8

  2. A - Panel thickness
    B - Inner unit diameter
For Metal W5/16
W3/8
Ply Wood Panel 12 W5/16
W3/8
16 W5/16
W3/8
24 W5/16
W3/8
Plastic Cone For Beam
Type D

Inner Unit W1/2 is only used.

Tapered P Cone

For the leaning panel constructure.

Bedding Plug

It is used to seal the hole which is 
made because the Cone is removed 
after the concrete has set

ACCESSORY TOOLS
FORMTIE Spanner

To be used to fasten FORMTIE and Inner Unit and remove them.

Box Spanner D and B

To be used to remove Cone.

U Clip
0.18kg
L Pin
0.4kg
OTHER ACCESSORIES
L50 CONE
SLAB JOINTER
L50 CONE

9mm

SLAB JOINTER

9mm, 12mm

Shuttering Accessories

DROP-FORGED QUALITY FOR ALL SHUTTERING SYSTEMS

Indispensable: the Richee Tie-rod

An essential component among shuttering accessories is the Richee tie-rod. It matches all other items such as base plates, threaded base and header plates, wing nuts and hexagonal nuts.

DROP-FORGED QUALITY FOR ALL SHUTTERING SYSTEMS

The vote for long life material quality

Richee offers to the building industry a wide range of shuttering accessories of the highest accessories of the highest quality. Scaffolding couplers and shuttering components are mostly drop-forged, which offer significant advantages compared with accessories produced by other means.Drop-forgings have considerably better material properties, such as the greater toughness and tensile strength necessary to fittings under dynamic stress.

Drop-forged shuttering components will stand up much longer to hostile building site conditions owing to their greater wear resistance and they also offer the benefits of a markedly higher load factor.

Tie-rod

15 mm ø, load: P permissible
91 kN (DIN 18 216).
(Continuous thread, Dywidag dimensions)

Wing nut, two-wing

Drop-forged
Material: C 35
Thread: 15 mm ø

Anchor nut 100

Drop-forged
Material: C 35
Thread: 15 mm ø

Water barrier

Thread: 15 mm ø




Water stop

Type G: cast iron

Setting cone

All galvanized and with movable contact rim, screw-in length restricted by stop pin, other cone dimensions upon request

Hexagon nut, width across flats 30

Length: 105 mm
Thread: 15 mm ø

Steel / plastic cone

Thread: 15 mm ø with reinforced base edge to protect the shuttering 
Cone casing material: St. 50.2 steel, galvanized
Length / width across flats: 100 / 30 mm

Push-in cone

For tube supports
Material: PVC

Plug

For resealing tube supports
Material: PVC

Clamps & Pipe Accessories

PIPE ACCESSORIES / METAL FORM AND ACCESSORIES

48.6 Base

48.6 Pipe joint

42.7 Pipe joint

Expanding joint pin (Bone Joint)

42.7 Base

Jack base

SCAFFOLD CLAMP / PIPE CLAMP / END CLAMP
Scaffold Clamp (Fixed type)
Pipe Clamp 60.5 X 48.6 Swivel clamp
End Clamp

Swivel type O (Vertical)

Swivel type O-3

Swivel type O-1 (Horizontal)

Swivel type O-1

Social links